# What parts do I need to build a SeedSigner?

> A Raspberry Pi Zero (2 WH is best), a 1.3-inch 240×240 LCD HAT, a Pi Zero camera with the short ribbon, a microSD card and a micro-USB power cable. No soldering if the pins are on.

- Web version: https://few.guide/answers/seedsigner-parts-list.html

## Steps

1. Board: Raspberry Pi Zero 2 WH. Fast, pins already on. A Pi Zero WH also works, just slower.
2. Screen: a 1.3-inch LCD HAT, 240×240 pixels, with joystick and 3 buttons. The project lists the Waveshare 1.3" model.
3. Camera: OV5647 sensor with the short, narrow “Zero” ribbon. Wider Pi camera cables won’t fit.
4. microSD card: any size. 8 or 16 GB is plenty. The software is about 50 MB.
5. Power: a micro-USB cable and any USB charger or power bank.
6. Optional: a case. Free 3D-printable designs are in the SeedSigner project.
7. Check live stock and prices on the parts tracker.

## FAQ

**Do I need to solder?**
No, if the board says “WH”. The H means the 40 pins are on. Bare board? A phone repair shop can add them in minutes.

**Does the Wi-Fi matter?**
No. “W” means the board has Wi-Fi, but SeedSigner never turns it on.

**Can I buy one ready-made?**
Yes. Pre-built units are on the parts tracker. You still flash the software and make your own seed.

## Go deeper

- [Full SeedSigner + Sparrow guide](https://few.guide/guides/seedsigner-sparrow.html)
- [Live parts tracker](https://few.guide/parts.html)